LED Controller Operation Instructions
1. Before powering on, check if the power supply voltage matches the controller's operating voltage and ensure there are no short circuits between the connecting wires.
2. After powering on, the controller will perform a self-test program. LEDs IC1-IC5 will each light up once, indicating normal operation.
3. After the self-test program ends, only one LED from IC1-IC5 will be lit, corresponding to the currently controlled IC model. You can press the chip button to change the controlled IC.
4. When the + speed and - up/down buttons are pressed simultaneously, the corresponding LEDs for IC1-IC5 will flash, indicating all modes are running in a loop. Pressing the + speed and - up/down buttons again simultaneously cancels the loop mode, and the corresponding LEDs for IC1-IC5 will remain constantly lit.
5. Each time the controller is operated, it will automatically save all current operating parameters. The next time it is powered on, the controller will execute the parameters from the last operation.
